4 H A B C D E F J G I K 4 English 6 Dansk DEutsch 40 RQ1090, RQ1062, RQ1060, RQ1052, RQ1050 with charger 58 suomi 78 noRsk 95 svEnska 4 57 6 English introduction Thank you for buying this Philips shaver. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. important Read this user manual carefully before you use the shaver and the Power Pod. Save the user manual for future reference. Danger - Make sure the adapter does not get wet. Warning - Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. - The adapter contains a transformer. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. - The shaver and the Power Pod are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. - Children should be supervised to ensure that they do not play with the shaver and the Power Pod. caution - Do not use the shaver, the Power Pod or the adapter if it is damaged. - Charge and store the shaver at a temperature between 5°C and 35°C. English 7 - Always put the protection cap on the shaver to protect the shaving heads when you are travelling. - Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. - Only use the adapter supplied. - If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. - Never immerse the Power Pod in water, nor rinse it under the tap. compliance with standards - The shaver complies with the internationally approved IEC safety regulations and can be safely cleaned under the tap. - These Philips appliances comply with all standards regarding electromagnetic fields (EMF). If handled properly and according to the instructions in this user manual, the appliances are safe to use based on scientific evidence available today. general - The adapter transforms 100-240 volts to a safe low voltage of less than 24 volts. overview (Fig. 4) Protection cap Shaving unit Trimmer Trimmer on/off slide Shaver (RQ1090/RQ1062/RQ1060/RQ1052/ RQ1050) F Shaver on/off button G Display H Power Pod A B C D E 8 English I Cleaning brush J Adapter K Small plug the display Before you use the shaver for the first time, remove the protective foil from the display. The five shaver types (RQ1090, RQ1062, RQ1060, RQ1052 and RQ1050) have different displays, which are shown in the figures below. - RQ1090 - RQ1062/RQ1060 - RQ1052/RQ1050 charging - Charging takes approx. 1 hour. - When you place the shaver in the Power Pod, the display automatically switches off after approx. 5 hours. English RQ1090 - When the shaver is charging, the minutes indication and the plug symbol flash. - The shaving minutes increase until the shaver is fully charged. RQ1062/RQ1060 - When the shaver is charging, the plug symbol flashes. - First the arrowheads of the bottom charge level flash, then the arrowheads of the second level flash, and so on until the shaver is fully charged. RQ1052/RQ1050 - When the shaver is charging, the battery symbol flashes blue. 9 Battery fully charged RQ1090 - When the battery is fully charged, the minutes indication is visible on the display and the plug symbol disappears from the display. RQ1062/RQ1060 - When the battery is fully charged, all arrowheads and all charge level lights light up blue continuously and the plug symbol disappears from the display. 0 English - When you remove the shaver from the Power Pod, the arrowheads of the top charge level light up blue to indicate that the battery is full. RQ1052/RQ1050 - When the battery is fully charged, the battery symbol lights up blue continuously. Battery low RQ1090 - When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the minutes indication and the plug symbol start to flash. - When you switch off the shaver, the shaving minutes and the plug symbol continue to flash for a few more seconds. You hear a beep when there are no minutes left. RQ1062/RQ1060 - When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the battery symbol flashes red and the arrowheads of the bottom charge level flash blue. - When you switch off the shaver, the battery symbol and the arrowheads of the bottom charge level continue to flash for a few seconds. English RQ1052/RQ1050 - When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the battery symbol lights up red. - When you switch off the shaver, the battery symbol starts to flash for a few seconds. Remaining battery capacity RQ1090 - The remaining battery capacity is indicated by the number of shaving minutes shown on the display. RQ1062/RQ1060 - The remaining battery capacity is indicated by the flashing arrowheads of a particular charge level clean shaver For optimal shaving performance, we advise you to clean the shaver after every use. - The tap symbol flashes to remind you to clean the shaver. Note:The displays of types RQ1062, RQ1060, RQ1052, and RQ1050 look different but show the same indication. Replace shaving unit For maximum shaving performance, we advise you to replace the shaving unit every two years. English - To remind you to replace the shaving unit, the shaving unit symbol flashes (all types) and you hear a beep when you switch off the shaver (RQ1090 only). This happens at the end of 7 successive shaves to remind you to replace the shaving unit. Note:The displays of types RQ1062, RQ1060, RQ1052, and RQ1050 look different but show the same indication. travel lock You can lock the shaver when you are going to travel. The travel lock prevents the shaver from being switched on by accident. activating the travel lock Press the on/off button for seconds to enter the travel lock mode. , The lock symbol appears on the display (all types) and you hear a beep (RQ090 only) to indicate that the travel lock has been activated. Note:The displays of types RQ1062, RQ1060, RQ1052, and RQ1050 look different but show the same indication. Deactivating the travel lock Press the on/off button for seconds. , The motor starts running to indicate that the travel lock has been deactivated. The shaver is now ready for use again. Note:When you place the shaver in the plugged-in Power Pod, the travel lock is automatically deactivated. English Blocked shaving heads - If the shaving heads are blocked, the shaving unit symbol and the tap symbol with exclamation mark flash. In this case, the motor cannot run because the shaving heads are soiled or damaged. Note:The displays of types RQ1062, RQ1060, RQ1052, and RQ1050 look different but show the same indication. - When this happens, you have to clean the shaving unit or replace it. - The shaving unit symbol and the tap symbol with exclamation mark continue to flash until you unblock the shaving heads. charging Charging takes approx. 1 hour. A fully charged shaver has a shaving time of up to 65 minutes, which is enough for approx. 21 shaves. The actual shaving time is calculated by the shaver. If you have a heavy beard, the shaving time may be less than 65 minutes. The shaving time may also vary over time, depending on your shaving behaviour and beard type. Quick charge After the shaver has charged for 5 minutes, it contains enough energy for one shave. Put the small plug in the Power Pod. Put the adapter in the wall socket. 4 English Pull at the top of the lid () and remove it (). 4 First insert the top of the shaver into the Power Pod () and then press the bottom part into the Power Pod (). Note:The shaver cannot be placed in the Power Pod when the protection cap is on the shaving unit. , The display shows that the shaver is charging (see chapter `The display'). using the shaver shaving Press the on/off button once to switch on the shaver. , The display lights up for a few seconds. Move the shaving heads over your skin. Make both straight and circular movements. - Shaving on a dry face gives the best results. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Press the on/off button once to switch off the shaver. , The display lights up for a few seconds and then shows the remaining battery capacity (RQ090/ RQ06/RQ060 only). English 5 trimming You can use the trimmer to groom your sideburns and moustache. Pull the shaving unit off the shaver. Press the on/off button once to switch on the shaver. , The display lights up for a few seconds. Press the trimmer slide forwards to slide out the trimmer. 4 You can now start trimming. 5 Press the trimmer slide backwards to retract the trimmer. 6 Press the on/off button once to switch off the shaver. , The display lights up for a few seconds and then shows the remaining battery capacity (RQ090/ RQ060 only). 7 Insert the lug of the shaving unit into the slot in the top of the shaver (). Then press the shaving unit downwards () to attach it to the shaver (`click'). cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. - Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. - Clean the shaver after every shave for optimal shaving performance. 6 English - You can clean the outside of the shaver with a damp cloth. - Regular cleaning guarantees better shaving performance. cleaning the shaving unit under the tap Switch off the shaver. Pull open the three shaving heads one by one. Rinse all three shaving heads and all three hair chambers under a hot tap for 0 seconds. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. 4 Carefully shake off excess water and leave the shaving heads open to let the shaving unit dry completely. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. , For thorough cleaning, switch on the shaver and immerse the shaving unit in hot water with some liquid soap for 0 seconds.You can also clean the shaving unit with some alcohol. English 7 cleaning the shaving unit with the brush supplied Switch off the shaver. Pull open the three shaving heads one by one. Clean the shaving heads and the hair chambers with the brush supplied. 4 Close the shaving heads. cleaning the trimmer with the brush supplied Clean the trimmer every time you have used it. Switch off the shaver. Press the trimmer slide forwards to slide out the trimmer. Clean the trimmer with the short-bristled side of the brush supplied. Brush up and down along the trimmer teeth. 4 Switch the shaver on and off and repeat step . 5 Press the trimmer slide backwards to retract the trimmer. 8 English Tip: For optimal trimmer performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage There are two ways to store the shaver or to take it with you when you travel: - put the shaver in the Power Pod. Make sure the protection cap is not on the shaving unit. - slide the protection cap onto the shaving unit to prevent damage to the shaving heads. Replacement Replace the shaving unit when the shaving unit symbol appears on the display. Replace a damaged shaving unit right away. For maximum shaving performance, we advise you to replace the shaving unit every two years. Only replace the shaving unit with an original RQ10 Philips arcitec Shaving Unit. Pull the old shaving unit off the shaver. Insert the lug of the new shaving unit into the slot in the top of the shaver (). Then press the shaving unit downwards () to attach it to the shaver (`click'). ordering parts The following parts are available: - HQ8500 adapter - RQ10 Philips arcitec Shaving Unit - HQ110 Philips Shaving Head Cleaning Spray English 9 Environment - Do not throw away the appliances with the normal household waste at the end of their life, but hand them in at an official collection point for recycling. By doing this, you help to preserve the environment. - The built-in rechargeable shaver battery contains substances that may pollute the environment. Always remove the battery before you discard or hand in the shaver at an official collection point. Dispose of the battery at an official collection point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Disposal of the shaver battery Only remove the battery when you discard the shaver. Make sure the battery is completely empty when you remove it. Remo ...